Icom Ui7 Am Fm Unit Install

: Reinstall the covers and perform a functional test. The AM/FM button should now cycle through the newly enabled modes. Compatible Transceivers

This is the magic trick. The UI-7 comes with a that screws into the bottom of the Icom controller (the VS-3 button goes up). Slide the controller onto the UI-7 dock. It clicks into place via a dovetail joint. Pro tip: Run your Controller cable (the OPC-2359) down through the gap between the dashboard and the windshield. Tuck it into the A-pillar trim. icom ui7 am fm unit install

Furthermore, the installation process invariably involves soldering. Consequently, the operator must have a temperature-controlled soldering station, quality solder, a desoldering pump or wick for removing old solder, and precision screwdrivers. Equally important is the preparation of documentation. The official service manual for the specific ICOM transceiver being modified (such as the IC-735, IC-745, or IC-751A) should be consulted to locate specific jumper points and connector slots. "Measure twice, cut once" applies aptly here; verifying the correct installation points via the schematic is essential to avoid costly missteps. : Reinstall the covers and perform a functional test

Before starting, ensure the radio is completely disconnected from its DC power source. Flip the radio over; the is installed in the of the unit. The UI-7 comes with a that screws into