Hw 130 Motor Control Shield For Arduino Datasheet Free [extra Quality] < iPad >

// Motor B reverse at full speed digitalWrite(IN3, LOW); digitalWrite(IN4, HIGH); analogWrite(ENB, 255);

void loop() // Forward at 70% speed digitalWrite(MOTOR1_DIR, HIGH); analogWrite(MOTOR1_PWM, 179); // 179 = ~70% of 255 delay(2000); hw 130 motor control shield for arduino datasheet free

Here is a free, ready-to-use code snippet to test the HW-130 shield. This code will accelerate Motor A forward, then reverse, and stop. // Motor B reverse at full speed digitalWrite(IN3,

Built-in thermal shutdown and internal ESD protection. Reset Button: Onboard button for Arduino system reset. Pinout and Hardware Configuration Here is a free

The L298P is a "low efficiency" driver compared to modern MOSFET drivers. It dissipates heat to control speed. If you require higher efficiency or are using 3.3V logic boards (like the ESP32), this shield may not